JSSC Cut Off: Qualifying Marks and How to Set a Target

A JSSC cut off is the minimum score a candidate needs to move ahead or to be selected. For the 2026 cycles, the technical graduate exam (JTGLCCE-2026) and the intermediate exam (JILCCE-2026), no official cut-off exists yet because the exams have not been held. What does exist is the minimum qualifying marks rule in the notification, and that is the best starting point for planning a target.

Treat every number on this page as a planning aid. Any expected cut-off you see anywhere is an estimate, not an official figure. Official results and cut-offs are published by the Commission on its website: https://jssc.jharkhand.gov.in/

Table of Contents

Two Kinds of Cut-Off in JSSC Exams

• Minimum qualifying marks: A fixed percentage by category that you must score in each counted paper, announced in the notification. Missing it ends your candidature even if your total is high.

• Merit cut-off: The score of the last selected candidate in each category and post, known only after the results. It depends on vacancies, difficulty and competition.

Minimum Qualifying Marks Reported

Reports of the 2026 notification list category-wise minimum percentages for the merit papers, although one summary gives a flat 30 percent instead. Because the sources differ, read the exact rule in the advertisement. The table converts the reported percentages into marks for planning.

These are indicative conversions of reported percentages and are not official cut-off marks. Paper I is qualifying as well, with a reported minimum of about 30 percent.

Previous Years' Cut-Offs

We could not verify category-wise cut-off figures for earlier JSSC exams from the Commission's own site, so this page does not quote them. Many websites publish past cut-offs, but figures differ between exams, posts and stages. Check any number against the result or cut-off notice on the official website before using it as a benchmark.

What Affects the Cut-Off

• Difficulty of the paper: A harder paper lowers raw scores, and so the cut-off.

• Number of vacancies: More vacancies in a category usually mean a lower merit cut-off.

• Number of candidates: A larger, stronger pool pushes it up.

• Normalisation: When the exam is held in shifts, marks are adjusted before the merit list is made.

How to Set Your Target Score

Cut-offs change every year, so use any past figure as a benchmark only and aim for a clear margin above it rather than a bare pass.

1. Start from the qualifying marks for your category: This is your floor in each paper.

2. Add a safety margin: Aim at least 15 to 20 percent above the floor in the language and merit papers.

3. Track sectional scores: A strong total with a weak section can still fail the minimum in a paper.

4. Watch accuracy: With negative marking, improve accuracy first and attempts second.